AP Physics 2 · Unit 13 · Geometric Optics
13.3 Refraction
Explain how light bends between media, apply Snell’s law to find refraction angles, and describe total internal reflection and its conditions.
1/6Light changes speed when it enters a new material
- Light changes speed when it enters a new material
- Frequency stays fixed while speed and wavelength change
- Snell’s law links the bending angle to both indices
- Snell’s law finds the refracted angle in one step
- Total internal reflection keeps light inside a higher-index medium
- Total internal reflection lets optical fibers guide light
- Check your recall
- Practice: 10 questions
Part 1 of 6: Light changes speed when it enters a new material
Picture a toy cart rolling from a smooth floor onto thick carpet at an angle. One wheel slows first, so the cart turns. Light behaves in a similar way when its speed changes.
Light travels fastest in vacuum, at . In materials it moves more slowly. The change in direction that comes from this change in speed is refraction.
The index of refraction, , compares the two speeds: . Here is the speed of light in the material. A larger means slower light. Water has , and typical glass has .
Key terms · tap one for its definition
refraction
Refraction is the change in direction of a ray as it crosses a boundary between media in which light travels at different speeds.
index of refraction
The index of refraction is the unitless ratio of the speed of light in vacuum to its speed in a material.
Part 2 of 6: Frequency stays fixed while speed and wavelength change
Speed is not the only quantity that changes at a boundary. The source sets the frequency of a wave, so the frequency stays the same. Since , a drop in speed means a proportional drop in wavelength.
In vacuum, . Dividing the two relations gives the wavelength in a material: . Speed and wavelength both shrink by the factor . The frequency does not change.
Worked example
Speed, wavelength, and frequency in glass
- Speed: .
- Wavelength: .
- Frequency: .
Answer: In the glass, and . The frequency stays .

Quick check
One question on the part you just read
Easy
Show answer and explanation
Answer: D · Worked explanation
Part 3 of 6: Snell’s law links the bending angle to both indices
Refraction angles are measured from the normal, as in reflection. The normal is the line perpendicular to the boundary.
Let light go from medium 1, with index , into medium 2, with index . Snell’s law says . Here and are the angles from the normal in each medium.
A ray entering a higher-index medium slows down and bends toward the normal. A ray entering a lower-index medium speeds up and bends away from the normal. A ray along the normal does not bend.
Key term
Snell’s law
Snell’s law is the relation between the indices of two media and the angles from the normal on either side of their boundary.
Part 4 of 6: Snell’s law finds the refracted angle in one step
To find an unknown angle, rearrange the law: . Then use the inverse sine on your calculator. Check that the calculator is in degree mode.
The same law works when light goes from glass into air. Now and , so the ray bends away from the normal. The angle is then larger than . Nothing else about the method changes.
Worked example
Refraction from air into glass
- Rearrange: .
- Substitute: .
- Take the inverse sine: .
Answer: The angle of refraction is about .

Quick check
One question on the part you just read
Easy
Show answer and explanation
Answer: A · Worked explanation
Part 5 of 6: Total internal reflection keeps light inside a higher-index medium
Now consider light going from glass toward air. It speeds up and bends away from the normal. As the angle of incidence grows, the refracted ray moves toward the boundary. At the critical angle, , it runs along the boundary at .
Beyond that angle, no refracted ray exists, and all the light reflects back. This is total internal reflection.
Setting in Snell’s law gives . Total internal reflection needs two conditions:
- The light travels from a higher index to a lower index.
- The angle of incidence is greater than .
Key terms · tap one for its definition
critical angle
The critical angle is the angle of incidence in the higher-index medium for which the refracted ray travels along the boundary.
total internal reflection
Total internal reflection is the complete reflection of light at a boundary when it goes from higher to lower index above the critical angle.
Part 6 of 6: Total internal reflection lets optical fibers guide light
An optical fiber is a thin strand of glass surrounded by a material of lower index. Light inside strikes the wall at large angles of incidence. It reflects completely each time, so it travels along the strand with little loss through the sides.
Worked example
Critical angle for glass
- Use .
- Substitute: .
- Take the inverse sine: .
Answer: The critical angle is about .
A ray in the glass that meets the air boundary at more than 42° reflects completely. A ray at a smaller angle partly refracts out and is lost.
The lower index outside the strand is essential. It guarantees that light goes from higher to lower index at the wall. Because the reflection is complete, a fiber can follow gentle curves and still deliver the light.
Check your recall[12 marks]
6 written questions. Answer each one in your head or on paper, then open the mark scheme.
- 1.Explain[2 marks]
Explain why a ray bends toward the normal when it enters a material with a larger index of refraction.
Show mark schemeHide mark scheme
Model answer
Light travels more slowly in a material with a larger index of refraction. By Snell’s law, must then decrease, so the ray bends toward the normal.
- 1 mark for stating that light slows down in the higher-index material
- 1 mark for linking this to a smaller angle from the normal through Snell’s law
- 2.Calculate[3 marks]
Calculate the angle of refraction for a ray in air () that strikes water () at to the normal.
Show mark schemeHide mark scheme
Model answer
, so .
- 1 mark for using
- 1 mark for substituting the values correctly
- 1 mark for obtaining about
- 3.Determine[2 marks]
Determine the wavelength in a material with of light whose wavelength in vacuum is 640 nm.
Show mark schemeHide mark scheme
Model answer
.
- 1 mark for using
- 1 mark for obtaining
- 4.Calculate[2 marks]
Calculate the critical angle for a material of index 1.60 surrounded by air ().
Show mark schemeHide mark scheme
Model answer
, so .
- 1 mark for using
- 1 mark for obtaining about
- 5.Describe[2 marks]
Describe the two conditions needed for total internal reflection.
Show mark schemeHide mark scheme
Model answer
The light must travel from a medium of higher index to one of lower index. The angle of incidence must also exceed the critical angle.
- 1 mark for stating that light goes from higher to lower index
- 1 mark for stating that the angle of incidence exceeds the critical angle
- 6.Identify[1 mark]
Identify the quantity that stays the same when light crosses a boundary between two media.
Show mark schemeHide mark scheme
Model answer
The frequency of the light stays the same.
- 1 mark for stating frequency

Practice this topic
10 quick-fire multiple-choice questions, easy to hard. Tap an answer to see if you're right and the worked explanation. (The written questions with mark schemes are under “Check your recall” above.)
0 right0 of 10 answered
Includes the 2 quick checks in the note above.
EasyIdentify[1 mark]
Show answer and explanation
Answer: D · Worked explanation
MediumCalculate[1 mark]
Show answer and explanation
Answer: B · Worked explanation
MediumCalculate[2 marks]
Show answer and explanation
Answer: D · Worked explanation
MediumCalculate[2 marks]
Show answer and explanation
Answer: D · Worked explanation
MediumCalculate[2 marks]
Show answer and explanation
Answer: D · Worked explanation
HardCalculate[2 marks]
Show answer and explanation
Answer: D · Worked explanation
HardJustify[2 marks]
Show answer and explanation
Answer: D · Worked explanation
HardPredict[2 marks]
Show answer and explanation
Answer: B · Worked explanation